Standard Swedish standard · SS-EN ISO 15512:2019

Plastics - Determination of water content (ISO 15512:2019)

Status: Valid

Buy this standard

Standard Swedish standard · SS-EN ISO 15512:2019

Plastics - Determination of water content (ISO 15512:2019)
Subscribe on standards - Read more Dölj
Price: 1 320 SEK
standard ikon pdf

PDF

Price: 1 320 SEK
standard ikon

Paper

Price: 2 112 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less
Preview this standard
Scope
This document specifies methods for the determination of the water content of plastics in the form of powder, granules, and finished articles. These methods do not test for water absorption (kinetics and equilibrium) of plastics as measured by ISO 62.
Method A is suitable for the determination of water content as low as 0,1 % with an accuracy of 0,1 %. Method B and Method C are suitable for the determination of water content as low as 0,01 % with an accuracy of 0,01 %. Method D is suitable for the determination of water content as low as 0,01 % with an accuracy of 0,01 %. Method E is suitable for the determination of water content as low as 0,001 % with an accuracy of 0,001 %. The stated accuracies are detection limits which depend also on the maximal possible sample mass. The water content is expressed as a percentage mass fraction of water.
Method D is suitable for polyamide (PA), polycarbonate (PC), polypropylene (PP), polyethylene (PE), epoxy resin, polyethylene terephthalate (PET), polyester, polytetrafluoroethylene (PTFE), polyvinyl chloride (PVC), polylactide (PLA), polyamidimid (PAI), it is especially not recommended for samples which can release NH3. Methods A, B, C and E are generally suitable for all types of plastic and moisture level.
Water content is an important parameter for processing materials and is expected to remain below the level specified in the appropriate material standard.
Six alternative methods are specified in this document.
— Method A is an extraction method using anhydrous methanol followed by a Karl Fischer titration of the extracted water. It can be used for all plastics and is applicable to granules smaller than 4 mm × 4 mm × 3 mm. The method can also be used for, e.g. prepolymer materials in the form of a powder that are insoluble in methanol.
— Method B1 is a vaporization method using a tube oven. The water contained in the test portion is vaporized and carried to the titration cell by a dry air or nitrogen carrier gas, ...

Subjects

General (83.080.01)


Buy this standard

Standard Swedish standard · SS-EN ISO 15512:2019

Plastics - Determination of water content (ISO 15512:2019)
Subscribe on standards - Read more Dölj
Price: 1 320 SEK
standard ikon pdf

PDF

Price: 1 320 SEK
standard ikon

Paper

Price: 2 112 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less

Product information

Language: English

Written by: Svenska institutet för standarder

International title:

Article no: STD-80012308

Edition: 5

Approved: 6/3/2019

No of pages: 52

Replaces: SS-EN ISO 15512:2016